Priming all six sides of your clapboard will both extend their lifespan and at least double the time until you need to repaint.
Prime and paint all six sides of exterior siding.
Finally since metal is such a good heat absorber avoid painting siding while it s getting direct sunlight.
According to the terms of lp s application instructions all exposed edges of lp smartside siding and trim must be primed and painted with approved paint to protect the siding substrate.
Additional primer is not needed field painting guidance for best results with our primed siding products.
Prime the cedar before you paint it.
Step 1 mask off the sections of the siding or trim you wish to leave unpainted or to leave for another paint color.
For best results fresh siding should be pre primed on all six sides with a stain blocking primer and top coated with 100 percent acrylic latex paint.
Since our founding in 1987 fine paints of europe has always advocated the tried and true traditional method of priming exterior wood on all six sides prior to painting and or installation.
Therefore do not prime the back side of the siding or trim.
Alkyd oil primers are recommended but one may choose a high quality latex primer as long as it contains stain blockers.
All smart siding panels come pre primed ready for finishing immediately after installation with a layer of your favorite exterior topcoat paint.
I would strongly suggest priming the front back edges and ends of your pine siding with an oil based exterior primer before installation.
Aluminum siding paint typically lasts from five to 10 years and.
The back side is better left unpainted.
Place a tarp over any windows or doors and tape them securely in place.
As long as the siding is clean you won t need to use a primer unless raw metal is exposed.
This will definitely help keep excess moisture out of the siding reduce extractive bleed and improve the appearance and longevity of the siding and finish.
Once the siding has been installed apply two coats of a top of the line latex exterior house paint to it.
Thoughts on pre priming of siding windows and doors.
I know it s a pain but well worth the effort.