Removing Row Of Siding

Slide the separating tool underneath the bottom edge of the siding piece that is directly above the piece.

Removing row of siding.

Look for a horizontal seam between two courses of vinyl siding. Cut the nails at the bottom of the row above the boards you re replacing. Use a mallet or hammer to gently drive the tip of the bar up behind the siding if necessary. Repeat until you re at the ground and then remove the surrounding trim.

If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in. How to remove and replace a section of vinyl siding. Removing a damaged section of wood siding is relatively easy. If the siding is hard to remove try tapping it with the palm of your hand.

Use a small hacksaw with a sharp blade. To remove the uppermost piece start at one end of the bottom of the first panel and push the end of the zip tool up under siding until it hooks onto the underside of the lip. Insert the siding removal tool where the panels overlap and pull down and out. Remove the nails one at a time to disconnect the entire length of vinyl.

Step 1 slide the thin edge of a flat pry bar carefully under the lower edge of the first piece of hardieplank siding to be removed. Isolate the piece of siding you need to remove and find its outermost edge on either side. The wedges which are 1 to 2 inches in. Use a cat s paw or other small pry bar to pull the nails from the course you need to remove.

If you have a hammer a cat s paw tool and a few wood wedges you can slide the siding out. Cutting the nails will let you remove rotted boards without damaging those your e saving. To get at the nails carefully wedge out the bottom of the siding 1 8 to 3 16 in. If it remains stuck double check to see if.