Nail the replacement siding board in place.
Replace one piece of wood siding.
Hold any pieces above the.
Make another cut with.
Slide the replacement siding board upward underneath its top neighbor.
Cut through the nails that are holding the old siding in place.
To remove and replace damaged siding.
Nail the replacement siding board into place initially by driving nails through the existing holes in the top board.
Cut the nails at the bottom of the row above the boards you re replacing.
An oscillating tool with a.
Project step by step 3 15 minute vinyl siding repair with a zip tool.
Carefully slide the flat pry bar behind the damaged siding in order to pry out the nails.
Pull up on the.
Use a square to mark the cutting lines centered on a stud.
When crosscutting the existing siding be sure to stagger the end joints so they aren t aligned.
Make sure that the board is flat against the side of the house.
Use a pry bar to remove the damaged siding.
Using the same process in step one unzip the piece of siding above the damaged piece and hold it out of the way.
Starting at one end of the damaged piece push the end of the zip siding.
Fill in the nail holes.
Be sure to nail into the existing holes on the adjacent siding.
Cut existing siding nails.
Run a utility knife horizontally along the entire length of the broken wood siding to score it.
Remove any nails from the top piece of good siding.
Nail straight down on the replacement board in order to hit studs.
How to remove and replace wood siding.
Place the replacement piece of siding in the proper location pushing up until the lower lip locks with the piece below.
Stagger butt joints if you re replacing multiple courses.
The nailheads on existing siding will indicate stud positions.
Cut the fiber cement siding to length wear approved dust protection.
How to change a piece of broken wood siding 1.
Use a small hacksaw with a sharp blade.
Take the replacement board fit it in place image 2 and nail it in with a hammer using galvanized nails.